Skip to main content

Outdoor PIR Sensor(IR+MW)

Expected to be released by the end of September 2025. Stay tuned for more updates!

1. Appearance​

pir-0

AppearanceDescription
Registration ModeGreen light flashes (250ms on / 750ms off) when powered on or network button held.
Find MeGreen light flashes (1s on / 1s off).
Signal Strength DetectionAuto-off after 2 min.
Strong: Green (3s on / 3s off)
Medium: Orange (3s on / 3s off)
Weak: Red (3s on / 3s off)
Lost: Red (250ms on / 250ms off)
Motion DetectedRed light flashes once every 500ms.

2. Packaging List​

pir-10

3. Add PIR Sensor​

  1. Click Home Security Hub , then click "+" and select "Add peripheral" .
  2. Pull out the insulation strip to power up the device , the green indicator will flash and the device will show in the App. *Note: If the device does not show in the App and green indicator is off , please press and hold the register button for 5s to try again.
  3. Assign a room and click the "Done" to finish adding. pir-1

4. Testing Instruction​

4.1. Signal Strength Test​

Click " common-settings "→ "Signal Strength Test"→ " common-play " to check signal strength. pir-2

4.2. Installation test​

Click " common-settings "→"Installation test" to start testing. Note: You can walk around to trigger the PIR,if indicator flashes RED, that means it is working properly.
Vertical View

pir-3

Side View

pir-4
The installation height is 1.8m ~ 2.2m.

pir-5

  • Note
  1. This product is only for indoor use. Please follow the instructions to install and use the product correctly. Do not touch the lens to avoid affecting the sensitivity of the product, if cleaning the lens, please disconnect the power and use a soft cloth dipped in a little alcohol then wipe. Please avoid using it in environments with significant temperature changes.
  2. The installation location should avoid being close to air conditioners,electric fans, refrigerators, ovens, and those that can cause temperature changes, avoid directsunlighton the product.
  3. This product can prevent accidents from occurring, but it cannot guarantee safety. For safety reasons, except using this product properly,please be vigilant and strengthen safety prevention awareness in daily life.

5. Installation Instruction​

  1. Unlock: Insert a small flat-head screwdriver into the groove and rotate 180°. pir-5
  2. Push the installation plate down and remove it in the direction of the arrow. pir-5
  3. Drill three mounting holes as shown in the picture, and fix the mounting plate on the wall with screws. pir-5
  4. Choose the wall mounting position, hang the detector on the installation plate, pull it down into place in the direction of the arrow, and rotate it 180° by inserting a small flat-head screwdriver into the groove. pir-5

6. Device Specifications​

ParameterValue
Auto paringSupport
Detection methodPassive infrared;Microwave
Detection Range12m
Detection Angle110°
Pet immunity10kg
White light filter6500Lux
Digital temperature compensationSupport
Wireless transmissionRBF Technology
RF Frequency868/915Mhz
RF methodTwo-way communication
RF distance3100m
RF SecurityAES-128
Find meSupport
Tamper protectionSupport
Sensitivity settingsLow, Medium, High, Auto
DigSensitivity settingsitalSupport
Battery life spanUp to 5 years (standby mode)
Operation temperature-20℃ ~ 65℃
Operation humidity10% ~ 95%
Mounting methodWall mounting
Mounting Height2.4m